This really is a good do-it-yourself project because it isn't hard and you can head off damage if you replace the seal as soon you can, rather than waiting for a plumber. You can do the task with a little bit of knowledge and some fairly simple steps.
The seal, on the bottom of a
toilet, where it rests on the floor, is a gasket made of a
ring of wax. You can buy a replacement at a hardware store.
Wax seal over drain pipe flange
This inexpensive seal can help prevent damage to flooring and sub-flooring...expensive items to repair if a leak is not repaired right away. Be sure to do this procedure when the temperature is at least 70 degrees Fahrenheit so the wax will be pliable.
If you are replacing a leaky seal on an existing toilet, you will want to wear rubber gloves and
start at Part 1; if you are installing a toilet in new construction, skip to Part 2.
- Be sure to shut off the water supply. You might be able to do this at the toilet, but you might need go into the crawl space or basement to cut off the water.
- Flush the toilet once or twice to empty the tank and bowl.
- Use a sponge to soak up and remove any remaining water in the tank and bowl
- Remove the caps over the nuts that hold the base of the bowl to the floor.
- Remove the nuts. You might need to use penetrating oil and pliers.
- Disconnect the water supply line.
- Gently rock the toilet back and forth to break the seal and any caulking present.
Use care to grip the bowl and not the tank. If you grab the tank, you could break or crack the tank where it is bolted to the bowl.
- Remove the remnants of the old seal from both mating surfaces. Go to Part 2.
Here are some helpful links:
- Unwrap the new wax seal, and place it over the flange on the floor with the round side up,
exactly centered over the opening. Be sure both bolts are in place.
- Lift the toilet and place it over the flange and seal, keeping the toilet as level as possible.
- Sit on the toilet to help the new seal do its actual sealing.
- Ensure the bowl is level.
- Replace the nuts removed earlier. Tighten the nuts by hand to avoid cracking the base of the bowl.
- Reconnect water line.
- Turn on water supply to let tank fill. You can turn the water supply on part way to let the
tank fill with lower pressure. This will take a bit longer, but the part-way setting helps prevent the dreaded "Who just flushed?" scream from another household member that may be scalded in the shower because of a surge in the cold water going into the toilet tank.
- Flush and check for leaks.
- Apply silicone caulk as needed to junction of bowl and floor.
- Wash hands with an anti-bacterial soap.