When a small meteor enters the earth's atmosphere, it goes from traveling through a vacuum to traveling through air. Travelling through a vacuum is effortless and takes no energy. If you have ever stuck your hand out the window while driving down the freeway, you know that traveling through air is far from effortless. Air creates a lot of drag.

A meteor moving through the vacuum of space typically travels at speeds reaching tens of thousands of miles per hour. When the meteor hits the atmosphere, the air causes friction and the meteor heats up so much that it glows. The friction of the air burns the meteor until there is nothing left. Re-entry temperatures can reach as high as 3,000 degrees F!

Obviously it would not be good for a spacecraft to burn up when it re-enters the atmosphere! Two technologies are used to allow spacecraft to re-eneter:

  • Ablative technology
  • Insulating tile technology
In ablative technology, the surface of the heat shield melts and vaporizes, and in the process carries away heat. This is the technology that protected the Apollo spacecraft.

The space shuttles are protected by special silica tiles. Silica is an incredible insulator. It is possible to hold a space shuttle tile by the edge and then heat up the center with a blow torch. The tile insulates so well that no heat makes it out to the edges. This page discusses the tiles:

    "Aerobraking tiles are produced from amorphous silica fibers which are pressed and sintered, with the resulting tile having as much as 93% porosity (i.e., very lightweight) and low thermal expansion, low thermal conductivity (e.g., the well known pictures of someone holding a Space Shuttle tile by the corners when the center is red hot), and good thermal shock properties. This process can be readily performed in space when we can produce silica of the required purity. "
These tiles keep the heat of re-entry from ever reaching the body of the shuttle.

Here are several helpful links: